Thoroughly clean the surface area where you are to apply the vinyl, clay bar if sticking on bodywork of car to remove any fine surface dirt. Do not use any oil or wax based cleaners.
If you are in a cold environment then it will be necessary to warm the vinyl up with a low setting on a heat gun or hair-dryer and also warm the area it is to be applied to the vinyl’s will not stick easily of they are cold or the surface is cold.
Place the vinyl with backing paper still attached and hold in place with masking tape or magnets at the top edge or graphic.
Peel back the backing paper keeping magnets or masking tape in place.
Apply graphic from top down smoothing out with a squeegee or cloth as you apply.
Any fine bubbles can be removed using the tip of a scalpel blade and rubbing with your finger